Number of grid units left-to-right (x axis)
width:

Number of grid units front-to-back (y axis)
depth:

Height of bin in standard units (multiples of 7 mm)
height:

Include hole for magnet (Zack's design is 6.5 mm) or 0 to omit magnet hole
magnet_diameter:

Include deeper narrow hole for screw (Zack's design is 6 mm) or 0 to omit screw hole
screw_depth:

If both screw and magnet are defined, include feature for better printing of magnet/screw overhang
hole_overhang_remedy:

Number of subdivisions along x axis (uniform divisions)
chambers:

Include overhang feature for label and control position, can be 'disabled', 'left', 'right', 'center', 'leftchamber', 'rightchamber', or 'centerchamber' (hover for more info)
When labelWidth (below) is nonzero and therefore not the full width of the bin, the label feature can be left, right, or center justified relative to the entire bin. If x-subdivisions (chambers) are 2 or greater, then 'leftchamber', 'rightchamber', or 'centerchamber' places a label feature on each subdivision, justified relative to the subdivision.

withLabel:

Include large corner fillet on the front
fingerslide:

Width of label in number of units, or zero to indicate full width
labelWidth:

Thickness of outer walls (Zack's design is 0.95)
wall_thickness:

Efficient floor option saves material and time, but the floor is not smooth (only applies if no magnets, screws, or finger-slide used)
efficient_floor:

Style of lip at top of walls, can be 'normal', 'reduced', or 'none'
lip_style:


Gridfinity Parametric Web Generator

Web OpenSCAD Customizer Project
Gridfinity OpenSCAD
Rotate